Operating Weight
Operating weight is one of the three most important parameters of an excavator (engine power, bucket capacity, operating weight).
Operating weight determines the excavator's class and the upper limit of its digging force.
Digging force ≤ m.
Working Weight
m: The coefficient of friction between the ground and the tracks.
If the digging force exceeds this limit, in backhoe operation, the excavator will slip and be pulled forward, which is extremely dangerous. In fronthoe operation, the excavator will slip backward.
Digging Force
Digging force is mainly divided into boom digging force and bucket digging force.
Both digging forces act at the root of the bucket teeth (the lip of the bucket), but the power sources differ: boom digging force comes from the boom cylinder, while bucket digging force comes from the bucket cylinder.
Ground Pressure Specificity
The magnitude of the ground pressure specificity determines the suitable ground conditions for the excavator to operate on.
Ground pressure refers to the pressure exerted by the machine's weight on the ground, expressed by the following formula: Ground pressure = Working weight ÷ Total area in contact with the ground
Track Shoes Equipping the machine with suitable track shoes is crucial. For tracked excavators, the standard for track selection is: use the narrowest track shoes possible whenever possible.
Common track type: Toothed track shoes.
Travel Speed For tracked excavators, travel time accounts for approximately one-tenth of the total working time.
Generally, two speeds are sufficient for the excavator's travel performance.
Traction Force Traction force refers to the force generated when the excavator travels, primarily depending on the excavator's travel motor.
These two travel performance parameters indicate the excavator's maneuverability and travel capability. They are reflected in the specifications of various manufacturers.
Climbing Ability
Climbing ability refers to the ability to climb slopes, descend slopes, or stop on a firm, flat slope.
Two methods of expression:Angle, percentage
Lifting Capacity
Lifting capacity refers to the smaller of the rated stable lifting capacity or the rated hydraulic lifting capacity.
Rated stable lifting capacity:75% of tipping load
Rated hydraulic lifting capacity:87% of hydraulic lifting capacity
Swing speed
Swing speed refers to the average maximum speed that the excavator can achieve when slewing stably under no-load conditions.
This means that the defined swing speed is neither the swing speed at startup nor the swing speed during braking; that is, it is not the swing speed during acceleration or deceleration. For typical excavation work, the swing motor accelerates or decelerates when the excavator operates within the range of 0° to 180°, and the swing speed stabilizes when it reaches the range of 270° to 360°.
Therefore, the swing speed defined above is impractical in actual excavation work. In other words, the actual swing performance required is acceleration/deceleration that can be expressed in terms of swing torque.
Engine power: Gross horsepower refers to the output power measured at the engine flywheel without power-consuming accessories such as mufflers, fans, alternators, and air filters.
Net horsepower refers to the output power measured at the engine flywheel with all power-consuming accessories, such as mufflers, fans, alternators, and air filters.
Noise Measurement: The main source of excavator noise is the engine.
Two types of noise are measured:noise level at the operator's ear and noise level around the machine.
